Factory Supply High Quality Multimode Patch Cord with connector in orange cable for FTTH Solution

Brand Kalinton

Product origin China

Delivery time 7-15 days

Supply capacity 100000pcs/month

Product Name: Factory Supply High Quality Multimode Patch Cord with connector in orange cable for FTTH Solution

Connector Type: --FC ---SC --ST ---LC ---MU ----MTRJ ---Customized

Polishment: ---UPC ---APC 8 degree

Fiber Type: ---SM,9/125 G652D ---SM,9/125 G657A ---MM,50/125(OM2) ---MM,50/125(OM3)
---MM,50/125(OM4) ---MM,62.5/125(OM1)

Cable Type: ---Simple ---Duplex ---Water-Proof ---Break out ---Ribbon ---Bundle

Cable Jacket: ---LSZH ---PVC ---OFNR ---Customized

Cable Length: ---0.5M ---1.0M ---1.5M ---2.0M ---3.0M ---5.0M ---Customized

Folding Edit Pay attention to this paragraph
The receiving wavelength of the light module at both ends of the fiber jump line must be consistent, that is, the two ends of the fiber must be the light module of the same wavelength. The simple distinction method is that the color of the optical module is consistent. In general, the short -wave light module uses multi -mode fiber (orange fiber), and the long wave optical module uses single -mode fiber (yellow fiber) to ensure the accuracy of data transmission.

Do not excessively bend and ring in the use of optical fibers, which will increase the attenuation of light in the transmission process.

After the optical fiber jumping line is used, it must be protected by a protective cover, and dust and oil will damage the coupling of the fiber.

If the optical fiber connector is soiled, it can be cleaned with cotton swab dipped in alcohol, otherwise it will affect the quality of communication.

1. Before use, you must wipe the fiber -jump ceramic core and the end noodles with alcohol and dehydrated cotton.

2. The minimum curved radius of the fiber when used is 150mm.

3. Protect the end surface of the insertion and the core to prevent injuries and pollution. After disassembly, bring the dust cap in time.

4. Do not look directly at the fiber end surface when the laser signal is transmitted.

5. When artificial and other non -resistant factors are damaged, the damaged optical fiber jump should be replaced in time.

6. Before installation, read the instructions carefully and install and debug under the guidance of the engineer of the manufacturer or dealer.

7. An abnormal situation of optical fiber network or system can be tested one by one one by one. When testing or excluding the jumper failure, you can do a cross test first, and you can usually use a visible laser pen to judge the entire optical fiber link. Or further use the precision optical fiber insertion damage to the loss instrument to test the various indicators. The indicators are within the scope of the qualification, and the jump indicator is normal, and otherwise it is not qualified.